---
title: "Dial-up modems had speakers so users could hear the call connect, a habit left over from hand-dialed phones"
url: https://badiyaa.com/dial-up-modem-speakers-handshake-explained/
published: 2026-11-17T11:12:00+00:00
modified: 2026-11-17T11:12:00+00:00
section: Tech
publisher: Badiyaa
---

# Dial-up modems had speakers so users could hear the call connect, a habit left over from hand-dialed phones

Dial-up modems had speakers so users could hear dialing and the handshake, a Hayes M1 default that muted the sound once the connection was made.

That shriek of beeps and static that filled bedrooms in the 1990s was not a side effect. Dial-up modems carried a small speaker on purpose, and the standard setting switched it on only for the part of the call worth hearing: the dialing, the ring and the electronic handshake. The moment the two machines agreed on a connection, the speaker went silent.

The reason runs back to the earliest days of computers talking over phone lines, when a person had to sit in the middle of every call.

## When humans placed the call

Before the 1980s, connecting a computer to a phone line was a hands-on job. With an acoustic coupler, a user lifted an ordinary telephone handset, dialed the number, listened, and then pressed the handset into a cradle fitted with a small speaker and microphone. The modem’s tones went into the mouthpiece and came back out of the earpiece.

Even modems wired straight to the line often worked the same way. The caller flipped the modem to “originate” mode, dialed by hand, waited for the far end to answer, and only then let the machines take over. The human ear was the monitoring system. You knew whether you had a busy signal, a wrong number or a modem on the other end because you could hear it.

## The Smartmodem took the human out, but kept the ear

That changed in 1981 with the Hayes Smartmodem, which let software tell the modem to dial, answer and hang up. Its command language, built by Dale Heatherington and Dennis Hayes, became the de facto standard that almost every later dial-up modem copied, and it included commands just for the speaker.

Here is how those speaker settings worked in the Hayes command set:

- **M0:** speaker off, completely silent during dialing.

- **M1:** speaker on until the remote carrier is detected, so the user hears dialing and the handshake, then silence.

- **M2:** speaker always on, so even the data hiss after the connection is audible.

- **L0 to L3:** loudness, from off up to the loudest level, on modems that supported it.

The M1 choice is the telling one. Once the computer handled dialing, the user lost the handset at their ear, so the modem played the call setup aloud instead. A familiar sequence meant things were working; a busy tone or a human voice saying “hello” told you something had gone wrong long before any error message appeared.

## What the noise actually was

The handshake is the two modems testing the line and negotiating how fast they can talk. Speeds climbed in steps over four decades: 300 bits per second with the Bell 103 standard in 1962, 2,400 with V.22bis in 1984, 28,800 with V.34 in 1994 and finally 56,000 with V.90 in 1998. Each faster standard had to probe the line more carefully, which is part of why late-1990s handshakes were longer and stranger than early ones.

To put those numbers in perspective, a 5-megabyte song file contains 40 million bits. At 56,000 bits per second, that is about 714 seconds, roughly 12 minutes, assuming a perfect line. At 300 bits per second it would take more than a day and a half.

In practice the full 56k was rarely reached. Noisy or long rural lines could drag connections down to 21.6 kilobits per second or lower, a slump common enough to earn the nickname “21600 syndrome.”

## The speaker outlived the need

By the late 1990s, cheap “soft modems” did their signal work in software and sometimes sent their sound through the computer’s sound card instead of a built-in speaker. Broadband then removed the dial tone altogether. In 2000, dial-up made up about 74 percent of US home internet connections; by 2013 only around 3 percent of Americans still used it.

For more on the companies that built early networking gear, read how [3Com, the Ethernet company Robert Metcalfe co-founded, ended up inside HP](https://badiyaa.com/3com-ethernet-metcalfe-hp-history/), or browse more explainers in our [Tech section](https://badiyaa.com/category/tech/).

The last big name left in September 2025, when AOL switched off its dial-up service after 34 years.

## Further reading

- [Wikipedia: Modem](https://en.wikipedia.org/wiki/Modem)

- [Wikipedia: Hayes AT command set](https://en.wikipedia.org/wiki/Hayes_AT_command_set)

- [Wikipedia: Dial-up Internet access](https://en.wikipedia.org/wiki/Dial-up_Internet_access)

*Image: Frunze103, CC0 via Wikimedia Commons*

*This article was produced with AI assistance and reviewed by our Editorial Desk. [How we work](https://badiyaa.com/editorial-policy/).*
